With over twice the lumen output of the basic tape, and the added benefit of it being covered in a pliable clear plastic, StarStrand™ Super Star, with StarChip™ technology, excels in performance and durability. The plastic cover keeps dust and dirt from landing directly on the board and makes keeping it clean easy. Super Star is available in pre-manufactured lengths with 4 pin connectors installed at each end for fast and sure installation. The minimum single run is 1’, and the maximum run is 50’ (Using the 4-Way Connector Accessory). The black PC board is backed with 3M adhesive tape for easy installation.
Plastic cover helps prevent static electricity from damaging the PC board.
Maximum run is 25 ft. before voltage drop.
However, if the driver is plugged into the four way connector, you may add another 25 ft. on the opposite side of the original leg doubling the maximum run to 50 ft.
Cuttable every 2 in., but once it is cut, the run is terminated, and it should be capped off with a silicone end cap (53269)
Can be connected by wall plug or direct wire.
Use the 12V 4-Way Connector and 2” sections to get 90º angles and turns.
The 12V 4-Way Connector can also be used to power branched runs up to the maximum. Positioning of the 12V driver is critical to limit the amount of drivers required for each installation. Position 12V driver in middle of, or corners of, runs and to power the 12V 4-Way Connector.
Connector Cords can be used between the driver and the first tape section, between sections, to go around corners and to extend runs.
Metal Channel can be used to install on irregular surfaces and also areas where tape will be visible and needs to be concealed.
12V Male End Cap and Silicone End Cap should be used at every termination whether tape is cut or not.
12V Dimming Controller will work on all 12V tapes except Aqua Star. 12V Dimming Controller is installed after the driver and before the first section of tape. There is a 140 watt capacity to this device.
Light Bulb: | LED |
Voltage: | 12 volt |
Usage: | Low Voltage |
Installation: | Damp Locations |
Listing: | , Eco-Friendly, LED, Energy Saving, Quick Ship, Energy Efficient, Title 24 |
Type of Cabinet Lights: | Under Cabinet Strip & Tape Lights |
Length: | 2 - 120 inches |
ET2 (Eurotech) Lighting, a Maxim Group Company, is a pioneer in innovative and unique modern home lighting designs. A diverse selection of quality chandeliers, pendants, wall sconces, ceiling light, and lamps are inspired by bold European designs. From hand-forged iron to hand-blown Murano glass, ET2 Lighting combines cutting edge materials with wonderfully futuristic designs.
et2-e53210
Manufacturer: ET2 Lighting
Model: E5321
Collection: StarStrand™ Collection
Voltage: 12 volt
Light Bulb: LED
Bulb is included free; Bulbs are not eligible for replacement
Installation: Damp Locations
Not an interior designer? We understand and want to help! Browse our Design Ideas page for andwers to common design questions and get tips on how to choose the lighting that's right for you! Click Here